Pond Cleaning Guidelines

Consistent maintenance is very important for a thriving pond. Cleaning a pond isn’t hard but you need to work on it every week between April and October. Look thoroughly to distinguish problems before they become serious. With a little servicing, an appropriately positioned and planted pond can be a joy, not a laborious task. Cleaning and taking care of a garden pond continually is important to keep the pond looking good and having healthy fish in it. So, here are our guidelines on how to clean a pond.

Ponds can become quite dirty, especially in the autumn when dead leaves fall and gather in the water; without correct maintenance, they can start to stench. Cleaning up your pond is a big task that needs a bit of labor, based on the size and contents of the pond. If you carry out frequent cleaning like algae control and cleaning the pond filter, you will only need to do a complete pond cleaning about once a year.

Ponds with just plants as regular residents are typically cleaned in the spring, but those with consistent koi fish should be cleaned in the autumn, before temperatures fall drastically. Fish are usually sluggish in the spring and can’t deal with as much hassle in that time that is why koi and fish pond cleaning is advised to do at the end of the maturing season, when fish are most healthy.

pondThe regularity of pond cleaning is yet another important thing to consider. It’s not recommended to clean them too often, like more than once a year, and less than once every three to five is even better. If you hold the pond clean all through the year by using netting to avoid leaf buildup and getting rid of plant debris as it starts to wilt, you don’t need to clean it too frequently. The inclusion of pond filtration methods can even more make your pond cleaning easier.

How to Clean a Garden Pond

While temperatures drop less than 70 degrees Fahrenheit, get your pond cleaning tools and get prepared to get dirty.

It is best to take out fish from the pond throughout a substantial clean-up for or else debris can get in their gills and usually cause shock and bad health. They should be placed in containers, already filled up with half fresh water and half pond water. Let enough time for the fresh water to evaporate any dangerous gases and chemicals. A lot will rely on your own tap water. Some have more or less chemicals which can be unhealthy for the fish.

If possible, remove plants before the water level gets too low. Oxygenating plants can usually be left for last, except if they are within easy grasp. With the dense oxygenators, it is advisable to leave them near the water edge for the night, to let any water snails, small frogs, and others accessibility back into the pond.

Once the pond is emptied and cleaned out, fill up it gradually over a couple of hours to help hold the water temperature as high as possible.

Put back the plants and fish when the water levels are close to usual and the temperature is around five degrees of the water when you removed it. Once the pond is full, turn on your pump and let the water to flow around for a while. Tap water has chlorine, so adding a dechlorinator to protect the fish may be a good idea.

 

 


Leave a Reply

Your email address will not be published. Required fields are marked *

Bookmarks


Subscribe to our e-mail list

Best Deals!

Enter your email address to receive the best offers and discounts on all pond equipment!

Recommended by us

webstats software
Solar Panel + Pump Kit